tile adhesive

1. product outline:
tile adhesive is one kind by the cement as the gelatinizer, the increase high polymer and the inorganic powder lot makes the new tile adhesive which the water retention agent, the cementing agent make, also suitably in ceramic tile thin layer caking.
Carries out the standard
JC/T547-2005        GB 6566-2001
 
2. the product explained:      
This by configurations and so on high-quality cement, padding, synthetic polymer and selection chemical additive becomes, joins the material powder weight 28% water, stirs 5min then to use fully.
 
3. product characteristic:
   1. The cohesive strength is high. cohesive strength latter being is pure cement 2~3 times.
   2. The construction performance is good. This has the good water retention property, the workability, the anti-class to fall the nature, but the time may about the Decca 20 minutes.
   3. Saves the cost. Because this caking powder belongs to the thin layer caking, may reduce the amount used greatly, saves the cost.
   4. Good durability. This has certain flexibility because, and is the thin layer caking, the resistance distorts ability enhancement, therefore has the good durability.
 
4.use and applicable scope:
This tile adhesive may widely apply on the concretes mortar wall surface, the ground as well as each kind of wall plate surface cakes the ceramic tile.
 
5.major technique target:

6.construction craft:
1) subsealing: The basic unit should level, firm, not floats the ash and the greasy dirt and so on, slightly has not the smooth place available adhesive to level.
2) stirs: The water consumption for the dried noodles weight 26%-28%, rests on needs thickness and the construction environment appropriate readjustment water consumption, poured into the dried noodles already installed the clean water in the barrel, was even with the mixer agitation, then settled 3 minutes, stirred evenly again then uses, after the watering, the cementing agent used in 4 hours finishes.
3) the shop pastes the ceramic tile: Will adjust the good cementing agent booth with the trowel to put down to the basic unit surface on, a time wipes the area should pay attention to the cementing agent to be possible to construct the time, generally is 20 minutes, after the booth even, carries on with the belt tooth trowel combs. The ceramic tile with the forcing on the combing cementing agent, the ceramic tile position may adjust in 15 minute about time. The shop pastes when the ceramic tile must keep the seam.
 
7.matters needing attention:
1) constructs the temperature should in 5℃ above, rains when please do not construct.
2) the shop pastes when the outer wall ceramic tile keeps the seam the deep bottom not to be able to be short in ceramic tile thickness half.
3) when this transportation and memory should pay attention to the waterproofing, moisture-proof, may store up for approximately a half year under the dry condition.
 
8. packing and storing:
1st,   This sack is weaves the bag to attach the internal membrane, 25 kilograms/bags
Puts on the carrier to takeoff storing, in order to avoid the rain water soaks, guaranteed that ventilates, dry, avoids the sunlight direct radiation.